Frequently Asked Questions About Thermography

Some things you just want to know more precisely. No matter whether it is a matter of a concrete practical application or a more general background information is required. In the FAQ, we have answered a few of the questions that customers often address to us. We hope the answers will help you solve your task. What you want to know, is not mentioned here? Then you can contact us by phone and e-mail at any time. Or simply use our contact form.

InfraTec sensor division faq - Picture Credits: © iStock.com / LuminaStock

Both terms refer to a device that is capable of registering the intensity spread of infrared radiation within a setting, visualising it as an image. While an infrared camera (also known as “imager” or “(passive) nightviewer”) rather serves to improve the perceptibility of people or objects in the dark or in hampered visibility, the task of the thermographic camera goes even one step further, i.e., its calibration permits to conclude the surface temperature of objects from the intensity of the detected infrared radiation.

In the vast majority of materials it is practically zero, i.e., measuring directly takes place on the material surface. There are only very few (partially) transmittant materials, such as oxides or silicates, where the measured value composes of layers that are at different depths within the object.

Not as a rule, since glass is transmittant by visible light in the same way as is near infrared, however, it is not beyond a wavelength of approx. 4 µm. This spectral range requires special infrared-transmittant window materials.

This, first of all, depends on the capability of the thermographic camera applied. State-of-the-art thermographic cameras permit non-contact temperature measuring as low as -20 ... -40 °C. Below this range, however, the infrared intensity irradiated by objects, and thus their signal-to-noise ratio, decreases so heavily that even considerable increases in device sensitivity would merely yield minute reductions of the lower measuring limit.

This is a question of wavelength. Infrared remote controls and infrared data-transfer distances make use of wavelengths in the near infrared range (e.g. 0.85 µm or 1.55 µm), while thermographic cameras work within the so-called “thermal infrared”, i.e., beside the more rarely applied range of 3 ... 5 µm, usually at 8 ... 14 µm – exactly the range in which also bodies show their maximum irradiation at room temperature.

Only under certain conditions; for the most frequent gases (such as the majority of constituents of the earth atmosphere) are largely translucent in the infrared range. Several gases, such as carbon and nitrogen oxides, also emit infrared radiation by themselves, although only within very narrow spectral ranges, so-called “bands“. Accordingly fitting spectral filters in the thermographic camera permit to adjust to this fact; however, it must be borne in mind that this requires a minimum temperature of typically a few hundred degrees Celsius as well as a minimal thickness of the gaseous layer to be measured.

Contact to Support

Do You Want to Know More About the InfraTec Service?

Our experienced service team will be happy to assist you.

Europe & Rest of World
InfraTec GmbH Infrarotsensorik und MesstechnikGostritzer Straße 61 - 6301217 DresdenGERMANY